Product Description
BRIGHT RED LED LIGHTS AND SOCKETS ... BYPASS YOUR CAR'S ELECTRICAL SYSTEM!
LED bulbs and sockets are typically used to wire a towed car for flat towing. They are permanently installed through the backside of the taillight housing. While towing, the LED's perform all turn signal, brake and park light functions at the rear of the towed vehicle.
LED's have significant safety and appearance advantages over incandescent bulbs. They are brighter, activate faster and have a much longer lifespan than incandescent bulbs. They are ideal for dinghy lighting systems because they generate almost no heat and can be used where incandescent bulbs would melt the taillight lens. Also, LED's draw significantly less power. The power comes from the front of the RV. The current must push through 40 to 60 feet of wire before hitting the bulbs at the rear of the towed vehicle. The LED's lower amperage requirements result in vastly brighter taillights when compared to incandescent bulbs.
The 152-2 includes two electrical pigtails, two sockets and two LED bulbs that illuminate red. This is important. White LED's behind a red lens result in pink colored taillights. Roadmaster specifically uses a bright red LED resulting in highly visible red taillights. Sockets fit a 1" diameter hole. Roadmaster also offers a 2 pack of red LED bulbs only, part number 152-50.
- Red LED bulbs for a truly red taillight appearance
- Low profile sockets fit the widest range of vehicles
- 450 Lumens of light output
- LED's are brighter, last longer and won't melt your taillight lens
- Includes two red LED bulbs, two sockets and two wiring pigtails
- Completely isolates the RV's wiring from the towed vehicle's electrical system
- Sockets have the same pin arrangement as an 1157 taillight bulb
- Satisfies legal requirements for towed vehicle lighting
Roadmaster also offers a towed car wiring kit with LED's part number 152-LED. This kit includes bulbs, sockets, molded wiring harness, split loom and all the common components needed for wiring the taillights of the towed vehicle.
Note: The LED bulb protrudes 1 7/8" from the surface of the mounting hole. Make certain your taillight has sufficient depth to accommodate these bulbs.
Quality Is Our Difference